Volume: 500ml, sold per bottle
Use protective gloves, keep out of reach of children and pets
VINYL WRAPPING AID
- This product is used to assist in the adhesion of vinyl wraps, to easily remove the trapped air between the body panel and vinyl.
TINT ADHESIVE REMOVER
- This product contains surfactants with special ingredients and petroleum solvents. This is purely neutral. it can easily penetrate to glue marks without harming interior plastics and heating wires. Fast acting and safe. This is formulated for removing tint adhesive residues and can be used on other adhesive residues on metals, walls, etc.
- INSTRUCTIONS: Remove first the old tint film. Spray on the adhesive residue in the glass. Leave for 20-30 seconds. Wipe clean with squeegee or soft cloth.
PPF ADHESIVE REMOVER JELLY TYPE
- Gel Type Adhesive remover
- Made from special surfactants and solvents. Pure, highly concentrated, and can dissolve adhesive residues quickly. The gel properties allow it to cling to the surface even on vertical panels to effectively penetrate to the adhesive residue.
- For fine or spot are ]area treatment: Choose jelly form, such as for curved surfaces like headlights and rearview mirrors
- INSTRUCTIONS: Spray a thin layer to target area and let sit for 1-2 minutes. Use a cloth to wipe off the dissolved adhesives. Repeat if necessary until all residues are removed.
PPF ADHESIVE REMOVER LIQUID TYPE
- Liquid Sprayable Type Adhesive remover
- Made of organic solvents, surfactants and special additives. Pure, highly concentrated, and can dissolve adhesive residues quickly.
- Evaporates too fast, thus requiring prompt operation
- For large-area adhesive removal: Choose liquid form, such as for decal adhesive removal from vehicle bodies
- INSTRUCTIONS: Spray a thin layer to target area and let sit for 20-30 seconds. Use a cloth to wipe off the dissolved adhesives. Repeat if necessary until all residues are removed.
- Work in well ventilated area.
TINT SLIP SOLUTION
- Slip Solution for Tint. Suitable for Car film, home glass film.
- Dilution ratio 1:300 to 1:500
- Made from variety of synthetic lubricating surface active compounds
- Colorless, odorless with high lubricity and cleaning power.
- INSTRUCTIONS: Mixed with clean water at a ratio of 1:300-1:500 and shake rigorously. Spray the film solution in a good proportion evenly to the surface.
- NOTE: You may add or reduce the solution if the surface is not properly lubricated.
PPF SLIP SOLUTION
- Slip Solution for PPF. Good for PPF positioning, lubrication and fixation of film.
- One bottle can make 5 liters of Slip solution mixed to a distilled water. Do not use on tap water.
- INSTRUCTIONS: Mixed with whole bottle A to a 5 liter clean water and mix. Then pour the B solution and mix well.
- Solution A: 250ml. Solution B: 20ml
