HOW TO USE MR. SQUEAKY WATER MARKS REMOVER:
- Rinse the glass to remove dusts on the surface and to avoid the liquid to dry immediately.
- Pour ample amount on the cloth provided.
- Rub firmly on glass until squeaky feel.
- Rinse immediately with running water or before the liquid dries off.
- Repeat if necessary.
DO NOT USE ON SIDE MIRRORS.
DO NOT USE UNDER THE DIRECT SUN LIGHT.
USE GLOVES TO AVOID SKIN IRRITATION.
This formulation is gentle enough not to burn the glass. Rinsing with running water is advised. If left without rinsing, the glass may become hazy. Use cerium oxide as remedy.
Use on GLASS SURFACES only. Windshield, windows, glass table, glass partition, glass sliding doors etc. Always rinse with water.
==========================================================
HOW TO APPLY GLASS TREATMENT:
- Clean the glass surface, better to remove the water marks or any chemicals to ensure the coating will stick to the surface.
- Put some drops of Mr.Squeaky Glass Treatment on the applicator block and cloth provided then apply evenly on same direction, on windshield, side mirrors and windows.
- Let dry for at least 15 minutes.
- Wipe off excess coating using paper towel or tissue paper.
- Ready to go, or you may test it by pouring water on the glass.
May use on all glass surfaces and MIRRORS. Do not forget to remove the coating after curing for at least 15 minutes. Paper towel or kitchen towel is best.
